Abstract
Abstract
An analysis of mould, spray and radiation zones of a continuous billet caster has been done by a three‐dimensional turbulent fluid flow and heat transfer mathematical model. The aim was to reduce crack susceptibility of the billets and enhance productivity of the billet caster. Enthalpy‐porosity technique is used for the solidification. Turbulence is modelled by a realizable k‐ε model. The three‐dimensional mesh of the billet is generated by Gambit software, and Fluent software is used for the solution of equations. In various zones, different standard boundary conditions are applied. Enhanced wall treatment is used for the turbulence near the wall. In the mould region, Savage and Prichard expression for heat flux is applied. In the spray cooling zone, the heat transfer coefficient for surface cooling of the billet is calculated by knowing the water flow rate and the nozzle configuration of the plant. The model predicts the velocities in the molten pool of a billet, the temperature in the entire volume of billet, the heat transfer coefficient in the mould region, the heat flux in the cooling zone and radiation cooling zone, and the shell thickness at various zones. The model forecasts that the billet surface temperature up to the cutting region is above the austenite‐ferrite transformation temperature (which is accompanied by large volume change). The model predicts a temperature difference of maximum 700 K between the centre and surface of the billet. The entire solidification takes place at 11.0 m length at 3.0 m/min. For the same casting arrangement, increasing the casting speed up to 4.0 m/min has been explored. Based on the simulation results, recommendations to alter the spray water flow rate and spray nozzle diameter are presented to avoid a sudden change of temperature.