Water accumulation in metered dose inhaler spacers under normal mechanical ventilation conditions

Objective The purpose of this study was to compare the water accumulation in 3 types of metered dose inhaler (MDI) spacer shapes in-line in a ventilator circuit, in 2 positions over 2-, 4-, and 6-hour time periods through the use of heated- and nonheated-wire ventilator circuits.Design The study design was prospective, quasiexperimental, and random assignment.Setting The study was conducted in a university laboratory.Materials Three brands of MDI spacers (OptiVent, ACE, AeroVent) were tested.Outcome measures Grams of water accumulation were measured.Intervention Distilled water accumulation was measured in 3 brands of MDI spacers in 0 degrees and 45 degrees positions at 2-, 4-, and 6-hour time intervals. Water accumulation was measured in each spacer by calculating the differences between pretest (dry) weights and posttest (wet) weights through the use of an analytical balance. A Marquest SCT-3000 servo-controlled humidifier with heated-wire ventilator circuit was used with a room temperature range of 21.7 degrees C-22.8 degrees C (71 degrees -73 degrees F) and a relative humidity range of 57%-65%.Results Multivariate repeated measures analysis demonstrated a difference between brands (P Conclusions We found that water accumulation was a result of the type of spacer, position of the spacer, and time that the spacer was left in-line. All 3 brands of spacer collected less than 5 mL of water over 6 hours in either position. Heated-wire circuits accumulated less water than nonheated-wire circuits and may be safer when using MDI spacers.