Abstract
This study aims to investigate the impact of varying the mass ratio of Ni to Graphene Nano Sheets (GNS) and how incorporating GNS affects the performance of a primary battery prototype (Ni/GNS//electrolyte//GNS). The primary battery prototype was developed using both impregnation and alloy methods. Different mass ratios of Ni/GNS to electrolyte to GNS were tested, including ratios of 1:2:1 (A), 2:2:1 (B), 1:2:2 (C), 2:1:2 (D), and 1:1:2 (E). The characterization of GNS, Ni/GNS, and the primary battery prototype involved using X-Ray Diffraction (XRD) and Scanning Electron Microscope-Energy Dispersive X-Ray (SEM-EDX) instruments. A multimeter was employed to measure electrical conductivity, energy density, and power density. A potentiostat/galvanostat was used to measure cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). XRD analysis showed a broad and weak peak at 2θ= 24.32° for GNS, confirming its successful synthesis. Additionally, a peak at 2θ = 43.5° indicated effective deposition of Ni on the GNS surface in Ni/GNS. The SEM-EDX results supported the XRD findings, showing regularly spaced pores and a thin surface layer in GNS. Notably, white spots on the graphene surface in Ni/GNS indicated successful Ni deposition. In terms of electrical conductivity, the highest value was observed in the primary battery prototype for sample D (2:1:2), which measured 1.11 S/cm2. These results were also supported by measurements of energy density and power density in sample D, which achieved the highest values among all samples, with 144,788 Wh/kg and 252,500 W/kg, respectively. Moreover, the CV and EIS measurements remained stable at 0.30 kΩ and 0.88 kΩ, suggesting that GNS could potentially conduct electrons owing to its electrical conductivity.